Printing on cylinder items H0906TX&H0906EI Gongzheng Group Co., Ltd. Revision History Version No. Ver 1.0 Date Revised by Description 2020-08-28 GZ Service Team First version of the manual Disclaimer and Copyright This manual is for personal use only. Any copying or transferal of this manual in whole or in part without the prior written permission of Gongzheng Group Co., Ltd. is prohibited. The operator should read through this manual completely. If possible, the operator need to participate in an enhance training in our factory or local distributor site. Gongzheng Group Co., Ltd. will be not liable for any kind of implied or expressed warranty or warranty liability for the content of this manual. Gongzheng Group Co., Ltd. will not be liable for any misprints, misstatements or omissions. If you find any misprints, misstatements or omissions, please inform us. Gongzheng Group Co., Ltd. will not be responsible for any loss or damage caused by using non-approved parts, improper operations. Gongzheng Group Co., Ltd. will revise/update this manual and the specification of this product without any prior notification. Please contact the local distributor if you suspect an error or an unclear point. 1) Press Crtl+F12 and input the password 222222 to enter the factory mode. 2) Choose 1HW1HC1HC1/2, 1HW1HC1HC1/3, 1HW1HC1HC1/4 or 1HW1HC1HC1/6 according to the diameter of the cylinder time in the factory mode. Small diameter item uses 1HW1HC1HC1/6. 3) After setting, save the change as a separate setting as below. 1/9 4) You will find the Head Select in Setting Tab has been changed. Here we take the 1HW1HC1HC1/6 for example. 5) Add a new material type (for example, Default 1/6) in Adjust Tabg. It is used to save the calibration settings specially for cylinder printing. 6) Put the Cylinder item on the cylinder printing unit. Move the carriage up to the position which is higher than the cylinder item. 2/9 7) Move the carriage above the cylinder item and adjust its position until the height sensor is aligned with the top of the cylinder item. Height sensor Top point of the cylinder item 8) Measure the Z Pos in the Z test. After then, click Y reset. 3/9 9) Move the carriage on the cylinder item, check if the middle point between the white head and color head is aligned with the top point of the cylinder item. If not, go to the factory mode and change “Hit limit back to zero distance” of y-motor until the middle point between the white head and color head is aligned with the top point of the cylinder item. 4/9 10) When you print on the cylinder item, unselect the Y Margin in the Setting tab. 5/9 11) Switch to Cylinder mode and print a line which 1-2mm width. Check if it is on the top of the cylinder item. Cylinder Mode 12) If the printed line is above the top line(red dotted line), please reduce the Hit limit back to zero distance, switch to Platform mode again and click Y Reset and switch back to Cylinder mode to make the test again. 6/9 Cylinder mode 1) If the printed line is below the top line(red dotted line), please increase the Hit limit back to zero distance, switch to Platform mode again and click Y Reset and switch back to 7/9 Cylinder mode to make the test again. Notes: Please be sure to click Save to save the settings you change in the Factory Mode. You need to test Hi limit to zero distance in platform mode. If the settings doesn’t work, please restart the printer. 8/9 Manufacturer: Gongzheng Group Co., Ltd. Add: Miaobei Village, Sanjiang District, Yongjia County, Wenzhou City, Zhejiang Province, China 325102 Tel:86-577-6731-9778 Website: www.gongzheng.com Email:gzsales@gongzheng.com/ service@gongzheng.com 9/9
